#LASERDRW TUTORIAL PDF#
#LASERDRW TUTORIAL WINDOWS 10#
#LASERDRW TUTORIAL SOFTWARE#

If the answer is no, go back to check it. The recommended speed for our polywood is around 8mm/s.ģ.3 Before hit ‘starting’, you need to activate our machine.ġ) Open air vent and cooling air (coming soon) Ģ) Plug in Laser cutter, water pump and exhaust fan (the socket is under the table) ģ) Connect your laptop to laser machine by blue USB cable ĥ) Load your material (like polywood) and close orange Protective Cover Ħ) Adjust the ‘Current Regulation’ to match your material (for example, plywood, the current is marked as below) ĩ) Hold the ‘Test Switch’ for one second to check if the laser cutter works. You can change the style according to your design. lyz file, and you will see the picture like following.ģ.2 Find the ‘Engrave’ and click it, then a small window will pop up as below. DXF file into Inkscape.ģ.1 Double click your. For example, I draw my pattern in Autodesk and save the design as.

#LASERDRW TUTORIAL SOFTWARE#

Or you can use other software for design, and import the design into Inkscape. zip(Laser Draw LYZ) as the picture shows. * Note: The software and its installation instruction will be attached(Window only).Ģ.1 We use Inkscape to design the pattern, shown as following.Ģ) Use BLUE lines to indicate vector engraving ģ) Use BLACK to indicate raster engraving (this can be shapes, paths or images)Ģ.2 After you finish your design, save it as. Hardware: USB key（shown as following picture）, Plywood Software: Inkscape, Inkscape extension, LaserDRW There are several materials you need to prepare before you use the machine. **Worning: For safety, it is better to have a training before use it.**

#LASERDRW TUTORIAL PDF#

Note: The PDF version of tutorial is attached here. By the support of included software, LaserDRW, this machine can work well with multiple graphic formats including lyz/bmp/jpg. It employs an USB port and thus can be connected to your laptop or desktop. This laser engraver is equipped with one 40W water cooling laser tube, high precise stepping motors, high quality control board. I would recommend K40 Whisper in any case and hope to see some added functionality down the road.We have a new machine in our lab! It is a laser cutter, which can be employed in both carving and cutting works. I had troubles with CorelDraw 12 part of CorelLASER on Win 10 and gave up on it.

#LASERDRW TUTORIAL WINDOWS 10#

The software runs fine on the latest Windows 10 and my old XP Pro system. Most likely my Visio doesn’t follow the current standard (typical Microsoft).ĥ. svg file is missing something that a Inkscape.svg file adds.

svg file is first imported or opened in Inkscape then re-saved. These can be sent to Whisper if the Visio. I’ve used MS Visio 2003 for years for quick 2D engineering sketches. With the CorelLASER extension speeds over were wonky.Ģ The Halftone raster engraving is very good and for my purposes makes the change to whisper well worth it.ģ.Inkscape, once you get use to a few non-intuitive methods (trim), is good and must be loaded on the computer.Ĥ. Other than it’s easier and cleaner than CorelLASER, there are a few outstanding differences.ġ.The cutting speeds are more true with K40 Whisper. I’ve been using the Inkscape/K40 Whisper duo for a few weeks or so and it is a quantum leap from the delivered SW.

Laserdrw tutorial